Electric power quality analyzer design using of open-source platform Arduino

Authors

  • Dušan Medveď Technical University of Košice
  • Patrik Šťastný Technical University of Košice

Keywords:

power quality analyzer, voltage measurement, current measurement, frequency measurement, Arduino, power quality, open-source platform

Abstract

This paper deals with the electric power quality analyzer design according to standard IEC 61000–4–30 category B. This analyzer is intended especially to control of electric power delivering and it should measure the basic electric parameters of one-phase low-voltage level supply grid. As for the analyzer concept there was used open-source platform Arduino.

Downloads

Published

2016-07-15

Issue

Vol. 9 No. 2 (2016)

Section

Generation of Electricity, Transmission, Distribution and Consumption of Electricity

License

Authors of the contribution acknowledge that the contributed article has not been up to the day published in any journal, neither has it been submitted for publishing in another journal. At a time, Authors delegate to the editorial board of ELEKTROENERGETIKA journal the authority to publish the contributed article on the journal Internet WEB page (http://jeen.fei.tuke.sk) at understanding that the journal editorial board assumes no responsibility for damages suffered due to use of acts, methods, products, instructions for use or other ideas published by the article authors, neither for by them advertised information. Authors represent that they are fully aware of the fact that articles are not being linguistically corrected by the journal editorial staff, and that they hence assume unlimited responsibility for lingual correctness.